ALR22T.2 EXTENDED FREQUENCY RX AND TX OF THE ALR22T & ALR22HT ALINCO 2 METER RADIOS. BEWARE OF ANY STATIC WHEN WORKING WITH THIS RADIO !!! 1 Remove the top and bottom covers of the radio. 2 Remove the 4 screws that hold the front panel ssembly to the main chassis. 3 Pull front panel away from the main chassis very gently. 4 Locate the Volume\Squelch pot on the left side of the radio. 5 Locate the VFO control on the left side of the radio. 6 Between the two above units is an IC that runs vertically between the two units. (ONLY THE 12 PINS OF THE IC ARE SEEN FROM THE BACK) 7 After locating the IC locate 3 sets of unsoldered jumper pads between the IC pins. 8 Make a solder bridge between the top 2 pads,then the middle 2 pads,then between the bottom 2 ONLY of the bottom set of 3 pads. CONTINUED IN FILE ALR22T.1