BC760XLT.1

THE FOLLOWING "MAGICAL" MODIFICATION WILL ALLOW RECEPTION OF CELLUAR PHONE
BAND ON A BEARCAT 760XLT. NOTE- THIS MODIFICATION SHOULD BE PERFORMED BY 
SOMEONE VERY FAMILIAR WITH ELECTRONIC COMPONETS.  THIS WILL ALSO VOID
YOUR WARRANTY.  AUTHOR ASSUMES NO RESPONSIBILITY WHATSOEVER.

1- Disconnect power cord from wall outlet, remove the four screws
   holding the bottom cover on.  Remove bottom cover carefully, speaker
   wires are attached.

2- Locate the large 64 pin microprocessor chip near front of the radio.
   Noting the indented dot which marks pin one, count along row to pin
   20.  Cut that pin close to the circuit board so if you ever want you
   could tack solder it back together. 

   Chip im my unit has following numbers:
   7D3
   HD 40740085
   JAPAN

3-  tTemporarily reconnect power to the radio and attempt to program 845.000
   Mhz., confirming cellur band restoration.  Frequencies may be entered in
   12.5 Khz, not 30 Khz, increments.

4- This completes the magical instructions, disconnect power, reassemble
   scanner in reverse order.  Rember performing this magic voids your
   warranty, not to mention the fact it is illegal and if the King's
   "henchmen" catch you, you mab be severely fined or maby even thrown into
   dungeon.