DJ16OT.6 The first three tones sent are the group code. This is followed by personal code of the person you want to PAGE. Then a star is sent, then YOUR personal code is sent as an identifier. Note carefully that it is the FIFTH (last) digit of the five digit DSQ number that is sent as the FOURTH digit of the DTMF transmission when you are in GP DSQ mode! Note too that this last digit is rewritten every time you RECEIVE a page, so if you want to send a personal page to someone OTHER THAN the person who paged you last, you must use DSQ SET to rewrite the last digit of your five digit code to specify the personal code digit of the person you want to page. Alternatively, note that when you enter GP DSQ mode by pressing [f] [GP DSQ] three times, the five digit code is displayed. At this point, entering a SINGLE digit will usually cause the fifth digit to be changed to whatever you want it to be. Pressing [f] [GP DSQ] a fourth time will put the radio in GP DSQ mode, removing the display of the five DSQ code digits. If no code is entered when the GP DSQ display of the code is called up, after about 5 seconds the display will automatically revert to the normal radio display with GP DSQ set. Alternatively, you can reset the entire DSQ display using the [f] [DSQ set] button combination. In any case, when using the GP DSQ (personal page) function, you must each time check the code to make sure you have set the personal and group code correctly. Be especially careful that the outgoing personal code (last digit of the display) is correct for the person you want to page. Summary of DSQ Code digits: 123.4.5 in display a b c a Three Digit Group Code. DTMF Squelch: (receive mode) These three digits must be received to break squelch when DTMF squelch (DSQ only displayed) is used. (transmit mode) These three digits only are transmitted when in DSQ mode upon pressing the [PTT] button. example: if you have set 123.4.5 as your DSQ code, when you press [PTT] in DSQ mode 1,2,3 will be transmitted. Group and Personal Page functions: These three digits are used as the group code in both group and personal paging functions and are the first three digits transmitted as part of a larger group or personal page code transmission. They are the first three digits that MUST be received when trying to activate a group or personal page. See below for more details. b This is YOUR personal page code. DTMF Squelch: This digit IS NOT USED in DTMF squelch functions. CONTINUED IN DJ16OT.7