FT11R.1

From: KA8WPC@KF8OW.#NWOH.OH.USA.NA


YAESU FT-11R AND FT-41R SQUELCH FIX

  If you are having a problem with the ht's squelch not setting right,
the following is a mod to put the unit into adjustment mode from the
keypad.  BE CAREFUL!  this mod has not been fully tested yet.
It will however cure the problem of the squelch opening when no signal
is present.


1. HOLD DOWN (CALL)(VOL UP)(VOL DWN) AT THE SAME TIME, AND PUSH THE
   POWER SWITCH.  THE DISPLAY WILL READ "S FULL"
2. PRESS (MHZ UP) 3 TIMES UNTIL "SQU TI" IS DISPLAYED
3. INJECT A .4uv SIGNAL AT THE ANTENNA INPUT. (THE FREQ SHOULD BE WHAT
   WAS DISPLAYED BEFORE ENTERING THE ADJUSTMENT MODE.)
4. PRESS (FM) FOR 1/2 SECOND. "AD" WILL BE BLINKING IN THE UPPER LEFT
   HAND CORNER.
5. PRESS (MR) AND THE BLINKING "AD" WILL STOP.
6. PRESS (CALL) FOR 1/2 SECOND, AND IT WRITES THE INFORMATION INTO
   THE EEPROM, AND RETURNS THE DISPLAY TO THE ORIGINAL OPERATING MODE.

 I say again, I don't know what the other functions are as of yet.
but if you are having difficulty with the squelch settings, try this.
It comes directly from YAESU.
                                             thanks es 73, -=MIKE=-


EOF DE KA8WPC@KF8OW.#NWOH.OH.USA.NA