FT736R.11 STAGE 2 Now you should have been using VFO A as the starting point, you should have 53.999.9 MHz in VFO B, and 00.000.0 MHz in VFO A. Press the Function KEY which is Marked with an ( F ), Followed by the PMS KEY ( KEY 5 ), You have Just stored your New Band Edges in to the PMS. Press the PMS KEY again, this time slowly Tune across the Two Band Edges, Until you see 999.999.9 MHz appear on your Digital Readout, Now whilst still in the PMS, Press the VFO B Button. These Next Few Steps Are Very Important 1/ Press The following KEYS ( KEY 9,KEY 2,KEY 4,KEY 9 in that order). The Magic Number is 9,2,4,9. 2/ Now Press the F KEY, followed by the PMS KEY. 3/ Press the PMS KEY again. You have Just stored the New Band Edges in to the PMS, you Should now have in VFO A, Which should be 00.000.0 MHz, and in VFO B, you should also have 999.999.9 MHz Press either of the UP of DOWN scan Buttons. You will now find that your FT736R will now scan up and down the Band from 00.000.0 MHz to 999.999.9 MHz, or from 999.999.9 MHz to 00.000.0 MHz. There are 3 other Mods for the FT736R, that you can do if your RIG as the Boards in it, Also there may be another Mod for the American 220 MHz Band but at the time of writing I do not know if it can be done. List of Mods for the FT736R as found by G0HEG and G7OHY. Mod 1/ is for the 144 to 148 MHz band, - RPT Plus Down MHz Button, Frequency 139 to 155 MHz. Mod 2/ is for the 430 to 450 MHz Band, + RPT Plus Up MHz Button, Frequency 425 to 459 MHz. Mod 3/ is for the 50 MHz Band, + RPT Plus Up MHZ Button. Frequency 45 to 56 MHz ?. Mod 4/ is for the 1296 MHz Band, + RPT Plus Up MHz Button, Frequency 1215 to 1326 MHz ?. Mod 5/ is for the American 220 MHz Band, + RPT Plus UP or DOWN MHz Button, Freuqency 216.6 to 230 MHz ?. All these Mods are for Receiving only and can not be used to transmit on. PAGE 2