FT736R.15

                                 STAGE 2
                                  
       Now you should have been using VFO A as the starting point,
       you should have 53.999.9 MHz in VFO B,
       and 00.000.0 MHz in VFO A.

       Press the Function KEY which is Marked with an ( F ),
       Followed by the PMS KEY ( KEY 5 ),
       
       You have Just stored your New Band Edges in to the PMS.

       Press the PMS KEY again,
       this time slowly Tune across the Two Band Edges,
       Until you see 999.999.9 MHz appear on your Digital Readout,
       Now whilst still in the PMS,
       Press the VFO B Button.

       These Next Few Steps Are Very Important
       
        1/ Press The following KEYS ( KEY 9,KEY 2,KEY 4,KEY 9 in that order).
           The Magic Number is 9,2,4,9.
        2/ Now Press the F KEY, followed by the PMS KEY.
        3/ Press the PMS KEY again.

       You have Just stored the New Band Edges in to the PMS,
       you Should now have in VFO A,
       Which should be 00.000.0 MHz,
       and in VFO B,
       you should also have 999.999.9 MHz

       Press either of the UP of DOWN scan Buttons.
       You will now find that your FT736R will now scan 
       up and down the Band from
       00.000.0 MHz to 999.999.9 MHz,
       or from 999.999.9 MHz to 00.000.0 MHz.

       There are 3 other Mods for the FT736R,
       that you can do if your RIG as the Boards in it,
       Also there may be another Mod for the American 220 MHz
       Band but at the time of writing I do not know if
       it can be done.

















                                 PAGE  2
CONT IN FT736R.16