FT736R.21

       MOD 2 For the American Version Only.

       some of these moves are the same.
       but you can do the European Version on an American RIG.
       Though you can not do the American Version on an European RIG.
                                                                       
                            Instructions

       Make sure that you put the Highest Frequency into VFO B,
       and the Lowest Frequency into VFO A.

        1/ Turn on your RIG.
        2/ Put the Rig into Repeater shift for the 144 MHz Band,
           By pressing the - RPT KEY (  KEY 5  ).
        3/ Set the OFFSET to 03.999.9.
        4/ Tune the RIG to the Highest Band edge,
           of 147.999.9 MHz.
        5/ Press the REV KEY (  KEY 5  ).
        6/ Press the DOWN MHZ Button.
    
       You Should now see 148.999.9 MHz on your Digital Readout.

        7/ Repeat Steps 5 & 6 Three times more,
           Alternating between both until you see 151.999.9 MHz
           on your Digital Readout.
        8/ Increase the OFFSET to 07.999.9.
        9/ Repeat Steps 5 & 6 Four time more,
           Alternating between both until you see 155.999.9 MHz
           on your Digital Readout.
       10/ Increase the OFFSET to 11.999.9.
       11/ Repeat Steps 5 & 6 Four Times more,
           Alternating between both until you see 159.999.9 MHz
       
       Keep on Increasing the OFFSET by 4,
       until you get the OFFSET to 99.999.9.
       And at the same time Keep on Repeating Steps 5 & 6
       Four times more after every Increase in the OFFSET
       until you get the Frequency to 245.999.9 MHz.
     
                                STAGE 2
                                   
       Now that you have 245.999.9 MHz in VFO B,
       And 144.000.0 MHz in VFO A,
       We come to the next move,
       Which is this,
       Press the Function key which is marked with an (F),
       Followed by the PMS KEY ( KEY 3 ),
       This stores the New Band edges in the PMS,
       Now Press the PMS key again,
       This time Tune to the Highest Frequency in the PMS,
       Which should now be 245.999.9 MHz.

       Make sure you have 245.999.9 MHz in VFO B,
       Make sure that the Frequency in VFO A is Lower than the Frequency
       in VFO B.
       Make sure that the Repeater shift is set to - RPT.
       Make sure that the OFFSET is set to 99.999.9.
        
        1/ Press the REV KEY ( KEY 5 ).
        2/ Press the DOWN MHz Button.


                                 PAGE 2

CONTINUED IN FT736R.22