IC32AT.6 <> Now find the CPU. It's the PGA under the shield near the top of the board. Find the row of pins on the CPU nearest the speaker. Notice the the 8th pin from the right has a thicker trace coming from it. Now notice that there are small solder pads about .25 inch toward the speaker on both the fat trace and the two traces to the right of it. Solder one each of the cathodes of the 2 diodes to the solder pads on the two smaller traces. This will open up the transmit for VHF & UHF. << Oh yes, note that memory channels clear when you do these. And the <> 11. Put unit back together in reverse order. This procedure worked for my unit, but I can't guarantee it will work for yours. <> Last but not least to enable cross band repeating first choose a pair of frequencies with the two vfo's for VHF and UHF.Then press and hold function key while pressing with the other hand the following "C" "6" "D". The radio will start scanning the two frequencies continiously, if a station is heard in one of the two it will retransmitted from the other! The two frequencies must be simplex, no cross band repeaters yet sorry! WR0Y, SV1IW, N1BIP, NV7F, and N7HMF all contributed to this.