TS830.4
6. now from the remaining terminal of your new switch, connect and run 
a wire to the if board to pins cw1-cw4. connect this wire to the green 
wire, that is connected to one of these pins. you will then have two wires 
connected to one of these terminals.

7. make sure tu have no solder shorts or bridges, make sure you have 
taped or insulated any bare wire connections. mount new switch in one of 
the spare holes on the baccof the radio. install the top aod bottom covers.


the modification works great, one position on the new switch and 
everything isnormal, in the other position the cw filter is placed in-line 
regardless of the position of the mode switch. to use the cw filters 
on rtty/amtor i found i had to turn the if shift control ccw to about 
the 9:30 position to center the tones in the passband. if you need an 
even narrower passband, just tighten it up a little with the vbt. 
good luck and good print!!!


from kf4nj - john..........RELAYED   BY...N0KGX...GENE