TS940 Average output power on ssb on the air conversations concerning a kenwood newsletter mod to change alc delay time called for putting a 2.2k ohm across the top of r137 and r104 on the control p.c.b , along with a .47 mfd cap between pin 1 and pin 2 of connector 8 on the control board.. the mod is excellent except .47 mfd is far too much.. instead use a .005 to .01 mfd to keep from over driving.. electrolytic not necessary, but if used, make sure nagative goes to shield wire pin.. from: bill k5bdz........RELAYED BY...N0KGX...GENE