Re: 405 rear suspension question
From: firepiston@juno.com
Date: Mon 02 Dec 2002 - 09:47:20 EST
Arlo at the Imported Car center would know where and how deep to drill.
His shop did many of these.
On Mon, 2 Dec 2002 08:14:52 -0600 "Bob Bruce" <bobbruce@mts.net> writes:
> I am installing grease nipples in the trailing arms on a 405
>
> I drilled through the steel and about 1/4" in there is a gap and
> then white plastic
> which is about 3/16" thick.
>
> So the question is how far in sould I drill so as to do the best job
> of lubing the bearings?
>
> Bob
>
>
> [Non-text portions of this message have been removed]
>
>
> Recommended format for your email subject lines:
> Model # [Model Letters] Year Subject
>
> Examples:
> 505 88 V6 Mileage
> 405 Mi16 89 Ignition Coil source?
> ************************************************
> To unsubscribe from this list send a blank email message to
> PEUGEOT-L-UNSUBSCRIBE@EGROUPS.COM
> ************************************************
>
>
> Your use of Yahoo! Groups is subject to
This archive was generated by hypermail 2.1.4 : Mon 02 Dec 2002 - 09:58:51 EST