Re: 405 Mi16 91 Timing belt job (help!)
From: Bob Bruce (bobbruce@mts.net)
Date: Sun 15 Dec 2002 - 13:02:36 EST
belt, 2 tensioners, water pump, crank seal, 2 cam seals
not a job for the amateur or the impatient
PSA says it requires a belt tensioner
might as well but in a set fo VC seals and gasket
at 150K it probably needs motor mounts, right and lower
rear A triangle bushing, and sway bar bushings
Put grease nipples in the trailing arms and a tube into each
This should take up a weekend
Bob
----- Original Message -----
From: mrburniemagnet@cs.com
To: peugeot-L@yahoogroups.com
Sent: Saturday, December 14, 2002 4:58 PM
Subject: [Peugeot-L] 405 Mi16 91 Timing belt job (help!)
Can anyone offer me any tips on this procedure. I recently purchased this car with 150,000 miles on it and I would like to do all precationary work to it. What other belts should I look to change along with the timinig belt (tensioner, alternator, serpintine)? I plan to change the water pump, fuel pump, and check the compression on the engine to see if further work is needed. Did I miss anything? I live in South Jersey (Blackwood). Are there any other Peugeot fans near me???
Thanks
Stefan
91 405 mi16
69 karmann ghia
87 renault gta
Recommended format for your email subject lines:
Model # [Model Letters] Year Subject
Examples:
505 88 V6 Mileage
405 Mi16 89 Ignition Coil source?
************************************************
To unsubscribe from this list send a blank email message to PEUGEOT-L-UNSUBSCRIBE@EGROUPS.COM
************************************************
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
This archive was generated by hypermail 2.1.4 : Sun 15 Dec 2002 - 13:02:47 EST