Peugeot Re: 88 505 N9TE 6flash continuing saga

From: Bill Doyle (bdoyle1492@earthlink.net)
Date: Tue 12 Mar 2002 - 18:19:44 EST

  • Next message: aaron11243: "505 4HP22 Temperature Sensor"

    Hello,
        arrrgh! I am dying here. At least I am not freezing anymore.
    I replaced both relays with the right Bosch ones. The old injection
    relay was a 15 amp, and terminal 87 and 87b on the relay itself were not
    connected internally like the new ones. Now I am getting the 2.2 ohms
    across 9 and 12.

     I also got another injection subharness. The old subharness (which
    feeds the injectors and the aux air valve) seemed to check out, at least
    as far as the continuity from terminal to terminal goes. I put the other
    one on.

      Problem is, I am still getting six flashes.

      I am having confusion over the B+ side of the injector connectors.
    When I have the key on, I am getting 12 volts on both sides of the
    connector. And when I check the continuity of Pin 12 against the
    injector connector with the battery disconnected, I get 6.2 ohms on one
    side and 4.4 ohms on the other side. Is it normal for there to be
    numbers like that?

       I will go over again what was already checked, without a problem found:

    Getting continuity between pin 8 of ign and pin 6 of inj
    Getting continuity on TPS connector and ign ECU.
    Charge voltage ok.
    Pins 11 and 13 <altitude sensor> - getting 2.45 ohms (should be 2-3) -
    checks out okay.
    Pins 7 and 13 - <intake air flow> - getting 1.15, (should be between 1
    and 2) - checks out okay.
    Pins 8 and 13 - <intake air flow> - getting 7.93, (should be between 7
    and 8) - checks out okay.
    Pins 8 and 9 - <ambient air temp>, getting 203 ohms, (should be
    150-250), checks out okay. Pins 5 and 8 - getting 375, (should be
    350-450) - checks out okay
    Pins 8 and 9- getting 204, (should be 150-250) - checks out okay
    Pins 5 and 7 - Funny AFM readings, but funny on higher end. Is at 80
    when not open. Significance questionable..
    12 volts at pin 9, with the key on.- checks okay.
    Wire 32E at relay and Pin 9, getting 00.0 ohms - checks okay.
    Wire 31 on relay. 00.0 ohms on one side of injector connector - checks okay.
    Resistor packet outer pin and injector B+, I can find a cooresponding
    pin which reads 00.0
    Continuity between center injector resistor pin and pin 12, getting
    00.0, - checks out okay.
     
      Is there anything else that I can check, and are my voltage and ohm
    readings sound correct on the injectors?

    BTW, I just got the book, so that will cut down on the simple questions.
     -Bill D.
       

    jsgrubbs2001 wrote:

    >Any change in your saga?
    >
    >-Joe G
    >

    This archive was generated by hypermail 2.1.4 : Tue 12 Mar 2002 - 18:20:16 EST