Re: Rewiring fan
Jim Lill (jpl@vectorbd.com)
Thu, 2 Oct 1997 22:13:14 +0100 (utc)
Looking at my Factory Wiring book for 1987/88 505, I believe the point to
access is MC15, a single terminal located in the engine area on the LH
strut tower. This is the break point for "run-only power" going to the to
the fans. It comes from pin 4 of the fuse block. If you disconnect that
and run the fan-side to +batt "hot at all times", the fan(s) will run
whenever the thermo-switch is above the "hot point". It's hard to say
what effect the A/C state will have on this without a lot of analysis. I'd
suggest you try a test jumper and see. If that gets you what you want, I
can then suggest a better place to pick up the +batt.
-Jim Lill http://www.vectorbd.com/users/jpl
On Thu, 2 Oct 1997, Alanh wrote:
>
> I found this on an Alfa Romeo Milano page and would like to know if you
> know of a way to do this on our pugs.
>
> BTW. Go to the Engine section and choose the "Rewire your fan...."
>
> http://reality.sgi.com/employees/sikand_mti/milano.html
>
>