I am in a dilemma. I have a 82' 505STD and the feed line to the hydraulic
clutch system broke. This introduced air into the system and the clutch is
not working. It goes to the floor without moving the slave cylinder and
thus the clutch. The hose was replaced and I tried to bleed the clutch in
the same manor that you bleed the break system. This didn't work. What is
the recommended way to clear this air from the system and thus re-enable the
clutch?
Thanks for the advice in advance.
Raymond Galloway
raymond.galloway@lmco.com
------------------------------------------------------------------------
------------------------------------------------------------------------