Re: 82' Clutch Problem

Douglas C Gruesbeck (fatfred@power-net.net)
Fri, 03 Sep 1999 10:29:03 -0400

One theory or idea I have heard about but never tried is to leave the bleed
screw open just a very little bit and let it set over nigh with the reservoir
full.

Douglas C

Galloway, Raymond wrote:

> Hi All,
>
> I am in a dilemma. I have a 82' 505STD and the feed line to the hydraulic
> clutch system broke. This introduced air into the system and the clutch is
> not working. It goes to the floor without moving the slave cylinder and
> thus the clutch. The hose was replaced and I tried to bleed the clutch in
> the same manor that you bleed the break system. This didn't work. What is
> the recommended way to clear this air from the system and thus re-enable the
> clutch?
>
> Thanks for the advice in advance.
>
> Raymond Galloway
> raymond.galloway@lmco.com
>
>
>
> MyPoints-Free Rewards When You're Online.
> Start with up to 150 Points for joining!
> http://clickhere.egroups.com/click/805
>

------------------------------------------------------------------------
------------------------------------------------------------------------