I have never seen a wire harness on the market that is compatible
with those Peugeot legos snap connectors. Some say they are, but they
aren't. I believe you will have cut off the old peugeot harness and match
up the peug wires with the new radios wires. There is a diagram online of
the wires and wire colors somewhere, I think. Not sure where. If you have
a volt meter and a basic understanding of DC current, you can identify each
wire yourself.
Any manufacturer will fit, if the unit is ISO-DIN size (or just
DIN). You will not need a $20 mounting kit regardless of what the
salesperson says. A new DIN sized radio will be the same width/height as
the Peugeot radio. The depth of the unit should be considered, but there
is a lot of room behind the radio on the 405.
Good luck,
Doug Sisson (3 years in Sears stereo dept.)
At 02:50 AM 1/19/01, you wrote:
>Hello folks!
>
>I am finally ready to replace my original peugeot radio with a cd
>player that has more power than the factory radio. I have installed
>new speakers and didn't do much for me.
>
>Does anyone know any manufacturer that would fit my current peugeot
This archive was generated by hypermail 2b29 : Fri 19 Jan 2001 - 08:05:59 UTC