• Previous message: PEUGPETE@AOL.COM: "Lock-"EASE""
• Next in thread: Pug NZ: "Re: Crack repair"
• Reply: Pug NZ: "Re: Crack repair"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

If it is in a non stress area and you merely are stopping the fluid
from leaking, drain it thoroughly (!) take carb cleaner (aerosol can)
and clean the crack. It might be adviseable to chuck a carbide in a
Dremel tool and "V" cut the crack some. Then mix up some JBWeld epoxy
and fill the crack after making sure no oil is wetting the repair
area. Make sure it cures in a warm shop 24 hrs before operation. The
key here being sure you have clean alloy for the epoxy to bond to!

Recommended format for your email subject lines:
Model # [Model Letters] Year Subject

Examples:
505 88 V6 Mileage
405 Mi16 89 Ignition Coil source?

• Next message: jpl@vectorbd.com: "Re: Re: Re: Your document"
• Previous message: PEUGPETE@AOL.COM: "Lock-"EASE""
• Next in thread: Pug NZ: "Re: Crack repair"
• Reply: Pug NZ: "Re: Crack repair"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2.1.4 : Sat 13 Mar 2004 - 18:39:07 EST