-----Original Message-----
From: Brian Holm, Peugeotholm [mailto:peugeots@plainfield.bypass.com]
Sent: Thursday, September 24, 1998 7:19 AM
To: Jim Lill
Cc: Turbo Mailing List
Subject: Forged pistons for n9te
I am considering placing an order with a piston manufacturer for forged
pistons for n9te.
For my own resale purposes, I would order two sizes, I think, one standard
D (91.655mm), and one oversize, either .1 or .4mm over, which are the sizes
Peugeot uses. Might as well go to .4, I think, if I am only doing one
oversize.
My preliminary inquiries suggest that my cost will be approximately $100
each in quantities of 50. If I could sell some sets in advance, to help
make up the minimum, I would only charge a small handling fee over my cost.
Any interest or suggestions?